The Native Delta Cast Video Input Device enables low-latency frame grabbing.
After creating the device, if you encounter the error 'stream is not running', you may need to recreate the device. To do so, right-click on it and select 'Recreate Device' or switch the 'Use Direct GMA or Gpu Direct' setting to off and restart Smode.
Supported Cards
12G-SDI card
-
DELTA-12G-elp-h 2i1c (input/output)
-
DELTA-12G-elp-h 40 (input)
-
DELTA-12G-elp-h 04 (output)
-
DELTA-12G-elp-h 20 (input)
-
DELTA-12G-elp-h 4c (input/output)
-
DELTA-12G-elp-h 2c (input/output)
-
DELTA-12G-elp-h 1c (input/output)
-
DELTA-3G-elp-40 (input)
-
DELTA-3G-elp-20 (input)
Flex
-
FLEX-12G 01 (output)
-
FLEX-12G 10 (input)
-
FLEX-DP 10 (input)
Troubleshoots
-
If the device is not available in the Video Input list, check in the License settings if there is a 'Video In Pro' flag:
-
For AMD FirePro or Radeon-Pro GPU, activate DGMA in Radeon pro settings and reboot the computer
-
If
you are not using deltacast to capture an Unreal stream
, activate "Use Direct GMA Or GPU direct" in Prefrence-> General->Graphic context Configuration.
-
If
you are using deltacast to capture an Unreal stream
, deactivate "Use Direct GMA Or GPU direct" in Prefrence-> General->Graphic context Configuration.
-
For Nvidia GForce: GPU -> Disable gpu-direct in Smode Setting and reboot Smode.
-
For AMD Radeon: GPU ->Disable direct-gma in Smode Setting and reboot Smode.
-
For Nvidia Quadro: gpu-direct works fine.
-
For Smode 9.1 and later versions, use the latest DeltaCast driver with the new installation process: VideoMaster_EndUsersInstallationGuide.pdf
-
If not found in Device Manager or with an error warning, ensure that the BIOS Boot UEFI is in compatibility mode (not Windows UEFI but Others).
-
If it appears in Device Manager but not in DCare, ensure the firmware update was successful. It may require running the install.bat file twice after two reboots.