ArtNet
Control Device - Use ArtNet Device as controller
This feature is only available in Smode Station.
An artnet Control Device allow to send or receive DMX messages over network via the Art-Net protocol (DMX over ethernet).

PARAMETERS
- Identifier
Identifies the Art-Net device
- Receive Activate Art-Net packet reception
- Local Input Local network address of the socket device identifier reception
- Reuse Local Port Allow local reception port reusing to let multiple software listening on it
- Send Activate Art-Net packet emission
- Remote Output Remote network address of the socket device identifier emission
- Broadcast Toggle emission broadcast mode (needs special broadcast IP like 255.255.255.255 or subnet broadcast like 10.255.255.255)
- Filter
Filter the input messages according to subnet and universe range to avoid flooding
- Min Ip Min client IPv4 address of the universe filter
- Max Ip Max client IPv4 address of the universe filter
- Min Port Min client UDP Port of the universe filter
- Max Port Max client UDP Port of the universe filter
- Min Universe (Universe Selector): Minimum universe value to accept
- Max Universe (Universe Selector): Maximum universe value to accept
- Local Start (Universe Selector): Custom Offset applyed on the Art-Net channels
- Time Base Frequency of sending messages. If set to null, message are sent as soon as output controller changes. (Warning, this can flood target devices when framerate is high)
- Send Sync Packed Synchronise the display of the previous DMX message through the differents devices. May create latency with old materials.
- Allow Partial DMXPacket Allow partial DMX packets
- Unicast Outputs (List of Universes Unicast Outputs): Allow you to send DMX message through specific Network/Universe/channels. Overwrite the filter